Tinker Kit

22 Item(s)

Set Descending Direction
per page

Grid  List 

  • TinkerKit Red LED - 5mm

    The LED is possibly the simplest actuator available. It’s a low power light source available in many colors. It lights up when powered from an Arduino pin.

    Learn More
    $3.99

  • TinkerKit Rotary Potentiometer

    Potentiometer is a commonly used variable resistor. Turning the knob, you vary the output voltage between 0 and 5V. This value is sent through the middle pin of the pot.

    Learn More
    $3.99

  • TinkerKit Touch Sensor Module

    The Touch Sensor is sensitive to skin contact.

    Learn More
    $5.99

    Out of stock

  • TinkerKit Tilt Sensor Module

    The Tilt Sensor can detect when it is at an angle.

    Learn More
    $3.99

  • TinkerKit Thermistor Module

    The Thermistor is a resistor whose resistance varies significantly (more than in standard resistors) with temperature.

    Learn More
    $3.99

  • TinkerKit Linear Potentiometer

    Linear Potentiometer is a commonly used variable resistor. It can often be found as a volume controller on radios and TVs. By moving the slider you can vary the output voltage between 0 and 5V. This value is sent through the middle pin of the pot.

    Learn More
    $5.99

  • TinkerKit Joystick Module

    The Joystick module is similar to analog joysticks found in gamepads. It is made made by mounting two potentiometers at a 90 degrees angle. The potentiometers are connected to a short stick centered by springs.

    Learn More
    $8.99

  • TinkerKit Hall Sensor Module

    A Hall sensor creates a voltage related to the magnetic field around the sensor. This can be used to detect distance from a nearby magnet. Hall sensors can also be used to detect the magnetic field induced in a wire or coil.

    Learn More
    $6.99

  • TinkerKit 2/3 Axis Accelerometer

    An accelerometer is a device that measures acceleration. It is very common in consumer electronics such as portable electronic devices and video game controllers to detect movement using accelerometers.

    Learn More
    $9.95

    Out of stock

  • TinkerKit Yellow LED - 5mm

    The LED is possibly the simplest actuator available. It’s a low power light source available in many colors. It lights up when powered from an Arduino pin.

    Learn More
    $3.99

  • TinkerKit Yellow LED - 10mm

    The LED is possibly the simplest actuator available. It’s a low power light source available in many colors. It lights up when powered from an Arduino pin.

    Learn More
    $3.99

  • TinkerKit Sensor Shield V.2

    The Sensor Shield v.2 allows you to hook up the TinkerKit SENSORS andACTUATORS directly to the Arduino, without the use of the breadboard.

    Learn More
    $9.80

  • TinkerKit Red LED - 10mm

    The LED is possibly the simplest actuator available. It’s a low power light source available in many colors. It lights up when powered from an Arduino pin

    Learn More
    $3.99

  • TinkerKit Power LED

    The Power LED is an actuator. Five ultra-bright LEDs can be powered from an Arduino pin.

    Learn More
    $8.99

  • TinkerKit Green LED - 5mm

    The LED is possibly the simplest actuator available. It’s a low power light source available in many colors. It lights up when powered from an Arduino pin.

    Input: Arduino provides a maximum of 40 mA per pin; this is enough to light up the LED through the digitalWrite() and analogWrite() functions.

    Learn More
    $3.99

  • TinkerKit Green LED - 10mm

    The LED is possibly the simplest actuator available. It’s a low power light source available in many colors. It lights up when powered from an Arduino pin.

    Input: Arduino provides a maximum of 40 mA per pin; this is enough to light up the LED through the digitalWrite() and analogWrite() functions.

    Learn More
    $3.99

  • TinkerKit DMX Receiver - Mos

    The DMX MosFet Receiver is a DMX module that mounts four mosfets; they can be individually controlled using a DMX master like TinkerKit!’s DMX Master Shield. Each mosfet supports up to 24V DC and the board runs at a range from 12V to 24V. A single master can control up to 512 receivers individually (128 of these boards for example) sequentially connected.

    Learn More
    $16.95

    Out of stock

  • TinkerKit Blue LED - 10mm

    The LED is possibly the simplest actuator available. It’s a low power light source available in many colors. It lights up when powered from an Arduino pin.

    Learn More
    $4.99

  • TinkerKit Text LCD - 16x02

    With the TKLCD module you can write text on the module’s screen in just minutes. It has an LCD display on board and requires a dedicated software library that is available on the tinkerKit! website.

    Learn More
    $6.99

  • TinkerKit 4 pin Wires - 55cm/21.5in

    55cm/21.5in long wire for the TinkerKit! Serial Port with a 4 pin jumper on both sides. Suitable for the LCD TinkerKit! Module.

     
     
    Learn More

    Out of stock

  • TinkerKit 4 pin Wires - 100cm/39in

    100 cm/39in long wire for the TinkerKit! Serial Port with a 4 pin jumper on both sides. Suitable for the LCD TinkerKit! Module.

     
     
    Learn More
    $2.95

  • Tinkerkit Male 3pin Connectors (pack of 10)

    Build your own Tinkerkit custom modules and connect them using the standard 3-pin Tinkerkit connectors. (datasheet)

    Learn More
    $1.99

22 Item(s)

Set Descending Direction
per page

Grid  List